Stone Cladding Fixing System Z Anchor Marble Bracket Expansion Bolt Nuts

Product introductionAs the metal fittings of stone curtain wall--stone dry pendant, although it is not exposed between the wall and stone, but it plays a vital role in beautifying the building decoration with the firmness and toughness of four or two thousand kilograms.There are many types of dry pendants, and each pendant has its own installation method.The method of dry hanging is directly related to the structure, installation, cost and aesthetics of curtain wall.In terms of the dry-hanging method of stone curtain wall, since the mid-1980s when it was introduced from abroad, it has become increasingly innovative, evolving from needle-pin type and butterfly type to the back-hanging and seat-hanging type up to now.The development and progress of dry-hanging technology has been completely separated from the monopoly of foreign technology, and the patented technology of dry-hanging which was developed by China itself has played a positive role in the reform and standardization of domestic dry-hanging curtain wall decoration.This product has long thread and is easy to install. It is usually used in heavy load facilities.To get a reliable, huge tightening force, you have to make sure that the clip ring that's attached to the gecko is fully inflated. And the expansion clip ring should not fall off the rod or distort in the hole.The calibrated tension values were all tested under the condition of cement strength 260~300kgs/cm2, and the maximum safety load should not exceed 25% of the calibrated value.

application fieldsSuitable for concrete and dense natural stone, metal structure, metal profile, bottom plate, support plate, bracket, baluster, window, curtain wall, machine, girder, girder, bracket, etc.

Advantage1. Anchors are fixed directly on to concrete walls with expansion bolts. 2. In horizontal joint installation slabs are pinned on the bottom and upper sides. Anchors act as load bearing carrying half. 3. The weight of the slabs above. Anchors also act as restraint holding the slabs below and restraining against wind suction and pressure. 4. In vertical joints installation slabs are pinned at the left and right sides. Anchors on the bottom are load-bearing anchors carrying the whole weight of the slab. Half the weight of the slab on the left and half the weight of the slab on the right. Anchors on the top are restraint anchors holding the slabs and restraining against wind suction and pressure.